BRESSER JDD-6 Spiral Daylight Lamp E27/45W
- Spiral bulb for continuous lighting in photo studios
- 5x higher light output compared with normal bulbs
- Energy-saving design, long lifespan, minimal heat generation
- Bulb length: 9.5 cm without fixture, total 16 cm
- Package contents: 1x 45 W spiral bulb
Currently not available
Product number:
F004258
EAN:
4007922016344
WEEE-Reg.-Nr.:
DE 34323861
Product information "BRESSER JDD-6 Spiral Daylight Lamp E27/45W"
A spiral bulb with a daylight colour temperature of 5500K.
This bulb fits to a standard E27 thread and is recommended for the continuous use in the studio. The light yield is 5 times larger than the light yield of a normal bulb. Besides, this spiral bulb is more energy-saving, lasts longer and doesn't become so warm.
fluorescence = light yield
26W = 125W
30W = 150W
35W = 175W
40W = 200W
45W = 225W
55W = 275W
85W = 425W
105W = 525W
125W = 625W
FEATURES
This bulb fits to a standard E27 thread and is recommended for the continuous use in the studio. The light yield is 5 times larger than the light yield of a normal bulb. Besides, this spiral bulb is more energy-saving, lasts longer and doesn't become so warm.
fluorescence = light yield
26W = 125W
30W = 150W
35W = 175W
40W = 200W
45W = 225W
55W = 275W
85W = 425W
105W = 525W
125W = 625W
FEATURES
- energy savings of up to 80 %
- low operating temperature
- E27 thread
- durable (8000 burning hours)
- no noise and no flickering
- 1x spiral daylight lamp
| Batteries included: | No |
|---|---|
| Batteries required: | No |
| Colour: | white |
| Energy efficiency class: | Lamp: A |
| Flash counter: | No |
| Flash lamp: | No |
| LED modelling lamp: | No |
| Lamp included: | No |
| Light source replaceable: | No |
| Metal reflector: | No |
| Overheat protection: | No |
| Photo cell: | No |
| Protection cap: | No |
| Synchro flash cord included: | No |
| Tilt head with tripod connection: | No |
Product and safety instructions
Manufacturer:
Bresser GmbH, Gutenbergstraße 2, 46414 Rhede
Contact:
www.bresser.de
www.bresser.de
Warning notes
- Safe workspace! Maintain order and avoid tripping hazards.
- Risk of electric shock! Completely switch off and disconnect the studio flash or lamp from the power supply before maintenance.
- Risk of burns! Allow the lamp or flash tube to cool completely before replacing it.
- Risk of breakage! Flash tubes and lamps are fragile – handle with care and avoid hard impacts.
- Explosion hazard! Use only original or approved replacement lamps and flash tubes to minimise risks.
- Correct installation! Insert the new lamp or flash tube into the socket according to the instructions.
- Keep dry! Do not use the device in humid environments and store spare flash tubes and lamps in a dry place.
- Risk of fatal electric shock! Never open a studio flash or lamp to replace or repair internal components.
- Proper disposal required! Dispose of damaged or broken flash tubes and lamps according to local regulations.
- Check correct voltage! Always ensure that the replacement lamp has the correct voltage and specifications for the flash head.
